how to setup virtual audio cable with audition

All cables, even inexpensive ones, have a unique combination of electrical properties.

An example of a 3-component electrical system in this context is a preamp and power amp with an interconnecting cable. Therefore measurable differences in the electrical properties of audio cables can and do affect how the music sounds and in a predictable way.Ĭonclusion #2 – Since each Interconnecting cable has its own set of electrical properties that impact the passage of signal, they should be considered to be an actual component of a three-component ‘electrical system’. These measurable differences in the electrical properties of cables can be correlated directly to the differences we hear in the sonic profiles of cables. In doing so we find there are a number of significant differences between different cables designed to do the same job. To make things clear I’ll present my conclusions now, at the start of this article, then show you quite simply how I’ve arrived at them.Ĭonclusion #1 – A cable’s electrical properties can be measured. I AM NOT in the camp of audiophiles who claim that expensive cables, by definition, must sound better than cheaper cables since they are more expensive.I do NOT fall into the ‘naysayer’ camp of audiophiles who claim that all cables sound the same.If anyone can shed some light on this issue what might be a good place to start looking for how to fix this because I used this before on a different PC and this setup worked fine and I've mirrored the configuration the best i could so I'm somewhat lost on the issue and i'm unsure if its some new quirk of OBS or a configuration issue in the Audio Cables.OK, it’s a long read ahead but I promise to keep this fairly simple at a technical level. The issue is that for some reason when using either Kernal or MMS audio repeaters I'm able to hear all audio just fine from all lines, OBS on the other hand only hears line 2 and line 2 only. This way i basically can monitor what the stream hears and i can just include or exclude certain audio when I want and just redirect 3 or 1 to my headset exclusively at any moment with a different repeater. Repeaters basically go this way 3->2 and 1->2 and 2->My Headset. I recently upgraded my PC and finally got around to re-installing and reconfiguring my Virtual Audio Cables again for streaming.

How to setup virtual audio cable with audition